SHAREBOT Next Generation Manuel d'utilisateur télécharger pdf (Page 40)

Just in case you have a dual-extruder and NG please make a double press extruder, load the prole

“SharebotDualstrusion”. Otherwise unnecessarily heating energy sprechereste the second extruder.

In the conguration le we included parameters related to all three tabs to allow you to have a start-

ing point for reliable and experienced. If you want to create dierent proles, you can adjust the

individual parameters and save congurations with a new name. We recommend that you do not

overwrite the basic proles provided by Sharebot.

Loading the model to print

In the tab “Plater” click on “Add” and upload your 3D model in STL format; Alternatively you can also

drag it within the program from an open folder. Will Center automatically Slic3r le without lay it on

printing: If your STL was created adjacent to the XY plane printing is doomed to failure.

You can upload multiple STL or upload multiple times the same STL doing what in jargon is called “im-

piattato”. For the dailies we recommend you try one le at a time.

Basic parameters of Slic3r

As seen earlier, Sharebot NG allows (thanks to proles PLA and ABS) generating G-Code by setting only

the geometric parameters of our interest: we can create not specic G-Code to individual materials,

leaving then set all the parameters of temperature, fans, etc., to determine the material to be used.

From this perspective, the basic parameters are those that go to geometric illustrate.

For further information please see Slic3r manual (manual.slic3r.org) and our courses (www.sharebot.

it/academy).

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 65 66

Pas de commentaire

SHAREBOT Next Generation Manuel d'utilisateur Page 40